Combination Ovens Instructions Welcome to Cadco! We want you to have immediate success with your new Cadco LineChefTM Combination Oven. These
10• Press the “Change set mode” touch pad to illuminate the “set temp” light next to the “Cavity” icon. • Set the “Climate % dial” to 100% steam. •
11When using the oven in a preset program mode, this touch pad can be used only at the end of the last time period. Each time the touch pad is presse
12 Procedure to use a saved program: • Using the “Program Selector Dial” find the number of the program you have decided to use. The number will be
13• Allow the solvent to work for about 10 minutes. • Program the oven to steam for 20 minutes, and activate. • Wipe away the grease and residue w
2 Installation of the Cadco LineChefTM Combination Oven. • Installation should only be performed by certified professionals, following all local co
3 3.1 Check the installation location Before placing the appliance, please verify the overall measurements and the exact position of the electr
4Place an omni-polar switch between the appliance and the network so that it is easily accessible. The contacts of this switch must have a minimum op
5 We are going to assume that you have followed all of your local codes and your new Cadco All-Purpose Oven is installed according to the procedures
6• 220v single phase power supply. • Thermostat accurate +-5f. • Temperatures up to 500°F. Your “CAPO” Oven can be used to: • bake all types
73. CONTROL PANEL • Time Select Dial •% Humidity •Climate Dial •Oven Temp Set •Probe Target Set • Probe Plus™ Set •
8TIME SECTION Cooking time control. • The time is displayed in hours and minutes. You can program it, in up to four cycles by pressing the touch pad
9To set the oven for combi cooking using time; • Activate the oven using the “On/Off touch pad” at the bottom of the control panel. • Press the “Ch
Comments to this Manuals